ADJUSTMENTS
2. Slightly turn adjustment screw (2) to adjust the horizontal
angle of laser line on the top of the board. If the laser line
is out of parallel from left to right, turn the adjustment
screw (2) clockwise; If the laser line is out of parallel from
right to left, turn the adjustment screw (2)
counterclockwise until the laser line is parallel with the
horizontal pattern line.
3. Recheck the laser line alignment.
After performing the above adjustments, visually check
that both the front and top laser lines are parallel with
pattern line.
NOTE:
• Laser line is calibrated and set up to project to
the left of the blade.
• If you have any problem or questions concerning the
Laser guide, call the following number for assistance:
01-800-70-56682.
SAFETY INSTRUCTIONS FOR BASIC SAW OPERATION
BEFORE USING THE MITER SAW
WARNING
To avoid mistakes that could cause serious,
permanent injury, do not plug the tool in until the
following steps are completed:
• Completely assemble and adjust the saw, following the
instructions. (ASSEMBLY AND ADJUSTMENTS)
• Learn the use and function of the ON/OFF switch, lock-off
switch, upper and lower blade guards, hold-down latch,
bevel lock handle and cover plate screws.
• Review and understand all safety instructions and
operating procedures in this Operator’s Manual. (SAFETY
& OPERATIONS)
• Review the MAINTENANCE and TROUBLESHOOTING
GUIDE for your miter saw.
• To avoid injury or possible death from electrical shock:
Make sure your fingers do not touch the plug’s metal
prongs when plugging or unplugging your miter saw.
(ELECTRICAL EQUIREMENTS AND SAFETY)
OPERATION
BEFORE EACH USE INSPECT YOUR SAW.
• Disconnect the miter saw. To avoid injury from accidental
starting, unplug the saw before any adjustments, including
set-up and blade changes.
• Compare the direction of rotation arrow on the guard to the
direction arrow on the blade. The blade teeth should always
point downward at the front of the saw.
• Tighten the arbor bolt.
• Tighten the cover plate screw.
• Check for damaged parts. Check for:
• Alignment of moving parts
• Damaged electric cords
• Binding of moving parts
• Mounting holes
• Function of arm return spring and lower guard: Push the
cutting arm all the way down, then let it rise until it stops.
The lower guard should fully close. Follow instructions in
TROUBLESHOOTING GUIDE for adjustment if necessary.
• Other conditions that may affect the way the miter
saw works.
• Keep all guards in place, in working order and proper
adjustment. If any part of this miter saw is missing, bent,
damaged or broken in any way, or any electrical parts don’t
work, turn the saw off and unplug it.
• Replace bent, damaged, missing or defective parts before
using the saw again.
• Maintain tools with care. Keep the miter saw clean for best
and safest performance. Follow instructions for lubricating.
Do not put lubricants on the blade while it is spinning.
• Remove adjusting wrench from the tool before turning it on.
• To avoid injury from jams, slips, or thrown pieces, use only
recommended accessories.
Fig. U
Fig. T
TOP VIEW
Laser line
Blade
Cutting line
Workpiece
Cutting line
Laser line
Fig. V
Laser line
Counterclockwise
Pattem line
Clockwise
Fig. W
Laser line
Pattem line
Counterclockwise
Clockwise
14
2
1
Summary of Contents for KN M-2508RC
Page 52: ...www knova com mx...
