TOOLS NEEDED FOR ASSEMBLY
5
UNPACKING YOUR MITER SAW
WARNING
To avoid injury from unexpected starting
or electrical shock, do not plug the power cord into a
source of power during unpacking and assembly. This
cord must remain unplugged whenever you are working
on the saw.
1. Remove the miter saw from the carton.
IMPORTANT: Do not lift miter saw by the trigger switch
handle. It may cause misalignment. Lift machine by the
built-in carry hand hold.
2. Place the saw on a secure stationary work surface.
3. Separate all parts from the packing material. Check each
of the illustrations shown below to make certain all items
are accounted for, before discarding any packing material.
WARNING
If any part is missing or damaged, do not attempt to
assemble the miter saw, or plug in the power cord until the
missing or damaged part is correctly replaced. To avoid
electric shock, use only identical replacement parts when
servicing double insulated tools. Call 01-800-70-KNOVA
(56682) for replacement parts.
Miter Saw
Hold-Down
Clamp
Dust Bag
3 mm Hex Key
Miter Handle
Blade Wrench
Rear Extension Stay
SUPPLIED
NOT SUPPLIED
Blade Wrench
Hex Key
Adjustable Wrench
Combination Square
Philips Screwdriver
Slotted Screwdriver
Draw light line on
board along this
edge.
Straight edge or a 3/4 in. board,
this edge must be perfectly straight.
Gap from untrue square
when flipped over.
COMBINATION SQUARE MUST BE TRUE
Should not gap or overlap when square is flipped over
(see dotted figure).
Operator’s Manual
CARTON CONTENTS
Summary of Contents for KN M-2508RC
Page 52: ...www knova com mx...