TRANSPORTING
8
• Transporting
To prevent fuel spillage when transporting or during temporary
storage, the generator should be secured upright in its
normal operating position, with the engine switch OFF
The fuel valve lever should be turned OFF.
When transporting the generator:
WARNING
• Do not overfill the tank
• Do not operate the generator while it is on a vehicle.
Take the generator off the vehicle and use it in a well
ventilated place.
• Avoid a place exposed to direct sunlight when putting
the generator on a vehicle. If the generator is left in an
enclosed vehicle for many hours, high temperature inside
the vehicle could cause fuel to vaporize resulting in
a possible explosion.
• Do not drive on a rough road for an extended period with
the generator on board. If you must transport the
generator on a rough road, drain the fuel from the
generator beforehand.
NOTE: To transport the generator, hold the holding part
(shaded areas in the figure 1).
Take care not to drop or strike the generator when
transporting.
Do not place heavy objects on the generator.
When transporting the generator by loading it on to a
vehicle, secure to the generator frame as shown
(see figure 2).
Holding part
figure 1
figure 2
ACCESSORIES INSTALLATION
• Accessories installation
• Two-wheel short axie (applicable to generator units
of KN GEN-30, KN GEN-65, KN GEN-80)
You can install the wheel assemblies for the convenience of
moving the unit.
You may need to prepare the following equipment before the
installation.
According to the different model configurations, there are
several kinds of wheels. Please install the handrail, vibration
reduction bracket and wheel on the base plate and tighten
the bolt as shown in the following picture.
Axle
Wheel
Handrail
Vibration reduction
bracket
Vibration reduction rubber pad
Cotter
pin
Washer
Summary of Contents for KN GEN-30
Page 32: ...www knova com mx...