9
ASSEMBLY
NOTE: If the cutting depth stop bolt has been adjusted
during operation of the old abrasive wheel, reset for the
depth for a new 14 in. diameter wheel. (See instructions
on page 9)
ADJUSTMENT
ADJUSTING THE CUTTING DEPTH STOP BOLT (FIG. F)
NOTE: The cutting depth was adjusted properly at the
factory. If adjustments are needed, be careful not to
adjust the depth stop bolt too deep, as the cutting
wheel may contact the base.
1. Loosen the locknut (1) with a 13 mm wrench.
2. Turn the depth stop bolt (2) with a 13 mm wrench
counterclockwise to decrease the cutting depth or
clockwise to increase the cutting depth.
3. Lower the cutting head to check that the wheel
does not contact the base.
4. Repeat until adjusted properly and tighten the locknut.
NOTE:
• To maintain this adjustment, the locknut (1) on the
depth stop bolt (2) must be tightened securely.
• The depth stop is factory set providing maximum
cutting capacity for the 14 in. abrasive cutting wheel
provided with your chop saw. When the diameter of
the wheel has reduced in size due to normal wear,
the depth stop bolt may require adjustment to provide
maximum cutting capacity.
NOTE: When a replacement wheel is installed onto the unit,
it is necessary to check the clearance of the cutting wheel to
the machine base before operating.
Fig. E
1
5
6
3
4
Fig. F
2
1
Summary of Contents for KN CS-3555R
