28
Manual Sync
NOTE:
The
Manual Sync
,
Manual Tracking
,
Horizontal Position
and
Vertical Position
options are
available only for analog computer sources. The projector sets these options automatically for digital
computer and video sources, with no manual override.
The projector adjusts signal synchronization automatically for most computers. But if the
projected computer image looks fuzzy or streaked, try turning
Auto image
off then back on again.
If the image still looks bad, try adjusting the signal synchronization manually:
1. Turn Auto Image off.
2. Highlight Manual sync, press
menu/select,
use the arrow buttons to adjust Manual sync until
the image is sharp and free of streaks, then press
menu/select
.
Manual Tracking
The projector adjusts tracking automatically to match the video signal from your computer.
However, if the display shows evenly spaced, fuzzy, vertical lines or if the projected image is too
wide or too narrow for the screen, try turning
Auto Image
off then back on again. If the image is
still bad, try adjusting the tracking manually:
1. Turn Auto image off.
2. Highlight Manual tracking, press
menu/select,
use the arrow buttons to adjust Manual tracking
until the fuzzy vertical bars are gone, then press
menu/select
.
Horizontal/Vertical Position
Follow these steps to manually adjust the position:
1. Turn Auto image off.
2. Highlight Horizontal position, press
menu/select,
use the arrow buttons to adjust the Horizontal
position, then press
menu/select
. Repeat for Vertical position, if necessary.
Positioning adjustments are saved when you turn off the projector.
Color Management Menu
Degamma
NOTE:
Your viewing preferences may vary. Cycle through the degamma options and pick the one
you like the best.
Degamma tables contain preset color configurations optimized for the type of source. You can
select a degamma table that has been specifically tuned for either computer, video, or film input.
Highlight
Degamma
, press
menu/select
,
use the left or right arrows to cycle through the options,
then press
menu/select
to select.
Color Space Standard
This option applies to computer and component video sources (it won’t appear in the menu for S-
video or composite video sources). It allows you to select a color space that has been specifically
tuned for your video input. When Auto is selected, the projector automatically determines the
standard. Choose RGB for computer sources, choose SMPTE240, REC709, or REC601 for
component video sources.
Highlight
Color Space Standard
, press
menu/select
,
use the left or right arrows to cycle through the
options, then press
menu/select
to select.
