• Connect battery to the inverter
• Please see section “Dip Switch Layout” to set up sensor
• Line up the diffuser with the 3 screw holes and fasten the screws
• Power up luminaire and check for correct operation
Fig 4
Fig 5
Neutral (blue)
Live (brown)
Switched Live (K)
• Mark the location of the fi xing holes and drill the holes ensuring not to infringe with any
joists, gas or water pipes or electrical cables
• Feed the cable via the entry point on the base of the luminaire
• Connect the Live (brown), Switched Live (K) and Neutral (blue) to the terminals on the
terminal block (see Fig 4)
• Remove the LED plate and disconnect from the driver (via the DC socket) and the emergency
inverter (via the YJD socket) (see Fig 3)
Dip Switches
(S1 to S10)
Daylight Sensor
Antenna
Module
Fig 3
L
K
N
3
