0900934 Rev: REL (05/09)
Page 15 of 16
OPERATION
When all system programming is complete, you will be ready for operation to dispense formula batches. Check that
all chemical lines are primed and that the water source is turned on (if applicable).
(1) Toggle the Main Power switch to ON position.
(2) Place container under the discharge spout (if applicable).
(3) Type in your user code and press ENTER, or use your proximity card (if applicable) — if your code was
accepted, the display will flash a brief acknowledgement and you will then see the following.
•
Chemicals will begin pumping, starting with the lowest number pump to the highest number (if there is more than
one pump programmed in the formula).
•
If simultaneous pumps option is turned ON, then all pumps on the formula will run together (if there is more than
one pump programmed in the formula).
•
The display will count down the remaining time left to dispense.
•
Users that have continuous batching allowances can press START again to dispense another batch without having
to re-enter their user code (providing that the continuous batching timeout period has not expired).
•
If the EXIT/ABORT button is pressed during operation, you will then see the following message.
PRIMING PUMPS
(1) Press the PRIME button.
(2) Enter your access code (main or user).
(3) Type in the pump number and press PRIME to start the pump.
(4) Press PRIME again to stop the pump.
(5) Repeat steps 3 & 4 as needed for any other pumps you wish to prime.
(6) Press the MENU
button to exit the pump prime function.
WATER ACTIVATION
Water (also called flush) can be activated manually at any time during pump operation. Press the WATER 1 or
WATER 2 buttons and the flush will activate for as long as the button is held down.
– The top line will show the current formula name.
– The bottom line will alternate between the date/time and the
display shown to the left.
Press FORMULA and key in the desired formula, then press
ENTER. Press
START
to begin dispensing.
FORMULA 01
SELECT FORMULA/HIT START
– If you press NO, the system will finish the batch as normal.
– If you press YES, the batch that is currently dispensing will be
aborted. When finished, the system will return to the default
display and will record the
actual
amount dispensed (instead of
the
programmed
amount) in the batch tracking memory.
NOTE: If you abort a batch, you may wish to flush the manifold
with water (if applicable) by using the manually activated water
buttons on the control panel.
ABORT CURRENT BATCH?
PRESS: YES OR NO
