1
Service
18
Parameter table
Menu
Description
User Access
Installer Access
Anti-cycling Time
No
Yes
Anti-cycling Override Differential
No
Yes
Ramp Delay (Enable/Disable)
No
Yes
Modulation Factor
No
Yes
Ramp Settings
No
Yes
Controlling Sensor (Outlet/Inlet)
No
Yes
Cascade Address = 0 (Leader Boiler)
i. Maximum Cascade Outlet Set Point
ii. Cascade Offset
iii. Cascade Differential
iv. Cascade Type (L/L, EFF)
v. Minimum On/Off Time
vi. Minimum Next On Time
vii. Minimum Pumps On
Cascade Adddress = 1 (Member Boiler)
i. Alternate Leader? (YES/NO)
No
Yes
Boiler Size
i. Cascade Address (1 - 7)
ii. Type (Condensing / Non-Condensing)
iii. Input (kBtuh)
No
Yes
BMS = ACTIVE
i. BMS Type = POWER
1. Rate at Minimum Volts
2. Rate at Maximum Volts
ii. BMS Type = SETPOINT
1. Set Point at Minimum Volts
2. Set Point at Maximum Volts
iii. Volts at Minimum
iv. Volts at Maximum
v. BMS Thermostat Input = INACTIVE
1. On Volts
2. Off Differential Volts
vi. ModBus / BACnet (ACTIVE/INACTIVE)
vii. BAS T/O
No
Yes
System Pump Delay
No
Yes
Boiler Pump Delay
No
Yes
DHW Pump Delay
No
Yes
System Pump Anti-Seize Delay
No
Yes
Boiler Pump Anti-Seize Delay
No
Yes
DHW Pump Anti-Seize Delay
No
Yes
System Pump Type (CFH, WWSD)
No
Yes
ANTI-CYCLING
CONTROL MODES
Service Manual
Table 1-4
SMART SYSTEM control module parameters
Note:
Parameter selections in
BOLD
are included in the Smart Setup Wizard.
(PAGES 25 - 26)
(PAGES 26 - 27)
(PAG
ES
27
-
28)
BUILDING MANAGEMENT
SYSTEM (BMS)
CIRCULATION PUMPS
(PAGE 29)
Summary of Contents for 100 Series
Page 51: ...51 Service Manual Notes ...
