K'Nex Rippin Rocket, Manual

Page: 6 / 69

Keep this important information for future reference.
• Remove rechargeable batteries from model before charging; they must be
charged only under adult supervision.
• Non-rechargeable batteries must not be recharged.
• Do not mix different types of batteries; do not mix alkaline, standard (carbon-
zinc), or rechargeable (nickel-cadmium) batteries. Do not mix new and used
batteries. Only batteries of the same or equivalent type recommended should
be used.
• Insert batteries with correct polarity (+/–) as shown.
• Remove exhausted batteries from model; do not short-circuit supply terminals.
• Requires 6 “C” (or LR14) batteries.
• Do not dispose of batteries in a fire; they could leak or explode and
cause injury.
• Remove all batteries if the toy will not be used for a long period
of time.
Track:
• It's important to adjust the Track, especially in the loop area, before
you finally cut the Track.
• If you cut the Track too short, you can use the Splice pieces to
re-connect it. Use a minimum of splices.
• Be sure to apply the Track so that it is very smooth. If the ends of
your Track are rough, trim a little off to make the ends a square,
clean cut.
Car Performance:
• For best operation, you may want to clean the sides of the car
periodically with a damp cloth.
• Car gets stuck at top.
A. If the Turbo Boosters are not running, check to see if the
batteries are fresh and installed properly.
B. Is Track built properly at top of frame?
• Car does not go through loop.
A. Check to see if loop is built correctly.
B. Is Track fully attached and smooth on the Track Connector?
C. Is return curve and frame built properly?
D. Do you have the right number of Track Connectors and are
they placed according to the instructions?
E. Are the support Connectors, that hold up the Track at specific
spots, on the proper side of the Flexi-rods?
To disassemble, you can use a
long green Rod to pop out the
orange Connector as shown.
T
IPS
& T
ROUBLESHOOTING
T
IPS
& T
ROUBLESHOOTING