30
7. Operation
Figure 7-1
Moving the copy grinding device
into change position
Figure 7-2
Mounting the copy grinding plate
2
1
For all work on / with the machine, the locally applicable safety and
accident prevention regulations as well as instructions in the “Safety”
and “Important notes” sections of the operating instructions must be
observed.
CAUTION
7.2 Switching on the copy grinding device
Switch the main switch (3-7/1) of the copy grinding device to the “I” position. The “Emergency
off” button (3-8/2) must be released.
Wait for the controls to initialize. The main screen will appear.
Press the “Control ON” (3-8/3) switch. The control is now activated.
Set the “Manual / Automatic” selector switch (3-8/8) to “Manual”.
7.3 Grinding the cutter knife
7.3.1 Mounting the copy grinding plate
To clamp on the knife, swivel the drive unit to the
change position.
Loosen the locking slide of the copy grinding de-
vice with the locking lever (7-1/1) and swivel the
drive unit to the right using the balance weight
guide rod (3-6/2).
Push the copy grinding plate (7-2/1) onto the
guide carriage ball bearings (7-2/2) to the stop
and press against the stop with the right hand.
Hold the “Change copy grinding plate” button
(3-8/5) until the copy grinding plate has moved
2 - 3 cm.
1
