D
ALTERNATE INSTALLATIONS
If joists change direction, 2 or all 4 Downrods (C&E) can be installed on the other 48" side. Rotate direction
of Angle Brackets (B) and Downrods (C&E) & install as shown in steps 1-3 of original instructions.
Multi-Directional Joists:
Peaked or Cathedral Ceilings:
Example Shown of
Multi-Directional Joists
If all Joists run parallel,
2 downrods can also be
installed on the other 48" side
by rotating direction of Angle
Brackets(B) as shown on
original instructions, but installing
downrods as shown here.
Adjust lower downrods at variable heights
if needed so that Support Frames(F&G)
will be level when installed. Continue with Steps 3 & 4.
Attach straight Down Rods(C)
to each Angle Bracket(B)
using 2 Hex Bolts(I) and
Hex Nuts(J). Tighten with ½"
Socket Wrench or Nut Driver.
Angled Joists
Clamp(K)
After installing Angle Bracket(B) to joists (step 1),
attach Downrod(C) to Angle Bracket(B).
Depending on your ceiling angle, you may need to
cut the corner from Downrod(C) to allow it to hang
down in the vertical position.
SuperPro 48" X 48"
Ceiling Mounted Shelf
Item # 00180 white
Item # 00183 hammertone
Page 6 of 12
