24
QTY
PART NUMBER
DESCRIPTION
ITEM
2
22-050-024
RATCHET ASSY
1
2
48-100550
CAPSCREW, 1X4-1/2 NC HX HD GD 5 PLT
2
2
48-100615
CAPSCREW, 1X6 NC HX HD GD 5 PLT
3
4
72-020125
LOCKNUT, 1" NC STOVER GD B PLT
4
2
69-080-004
PIVOT BRKT,SSL REACH
5
1
1
3
2
4
4
3
2
4
4
5
5
FINSHING TOOL ATTACHMENT:
Spiked Roller
ITEM PART NUMBER
DESCRIPTION
QTY
1
22-050-024
RATCHET ASSEMBLY
2
2
48-100550
CAPSCREW, 1 X 4 1/2 G5 PLT
2
3
48-100615
CAPSCREW, 1 X 6 G5 PLT
2
4
72-020125
LOCKNUT, 1 STOVER G”B” PLT
4
5
69-080-004
PIVOT BRACKET, SSL REACH
2
The Spiked Roller Attachment is not shipped in operating position because of height and width
restrictions. To reassemble, line up the lower hole in the pivot brackets (5) with the bushing in the
reach arm and insert the 1” x 6” capscrew (3). Thread 1” locknut (4) on the end of the bolt and tighten
until snug against pivot bracket.
DO NOT OVERTIGHTEN
. The pivot bracket should still be able
to rotate in the reach arm bushing. Repeat on opposite side. Attach the ratchet assembly (1) to the reach
arm using the included pin and cotter pin. Attach the opposite end of the ratchet assembly (1) to the
top hole on the pivot bracket (5) using the 1” x 4 1/2” capscrew (2). Thread 1” locknut (4) on the end
of the bolt and tighten until snug against pivot bracket.
DO NOT OVERTIGHTEN.
The ratchet
assembly should still be able to rotate in the pivot bracket.
To set the roller at operating depth, refer to the section on “
Operational Setup
”.
