STAR 14 PELLET BOILER STOVE
24
EN - Rev. 2.1
Working mode
During the working phase, by pressing 1, you can set the
“SET H2O”
(maximum water temperature in the boiler). When
this temperature is reached, the appliance enters economy mode operation
“T
-
H2O ECONOMY”
.
5°C before reaching the temperature set on
“SET H2O”
, the appliance starts modulating output by decreasing the pellet
intake and reducing the flue gas extraction speed.
For example:
“SET H2O”
set at 75 °C
Working power set at 5
-
Working power automatically changes to 4 when the temperature reaches 71°C.
-
Working power automatically changes to 3 when the temperature reaches 72°C.
-
Working power automatically changes to 2 when the temperature reaches 73°C.
-
Working power automatically changes to 1 when the temperature reaches 74°C.
-
Working power automatically changes to economy mode operation
“T
-
H2O ECONOMY”
when the temperature
reaches 75°C.
The appliance will now automatically switch itself off if at least one of the following conditions occurs:
-
If it remains in Economy mode Operation
“T
-
H2O ECONOMY”
for a time set on Pr44
(30 minutes as default setting)
.
-
If it exceeds the temperature differential set on Pr43
(set as default at 5°C),
in other words if Temperature H2O >
(“SET H2O” + Pr43).
The appliance automatically starts up again if the following condition occurs:
-
The temperature falls below the temperature differential set on Pr43 (
5°C as default setting)
or
H2O Temperature < (
“SET H2O”
– Pr43 ).
If the above condition occurs when the switch-off cycle is not yet completed, please wait until the cycle is complete.
The cleaning cycle of the brazier (displayed under
“BRAZIER CLEANING”
is done at predetermined time intervals for an
established period
(see “
PCB parameters”
)
.
Switch-off cycle
Pressing button 4 (ON/OFF) the appliance switches itself off. The display will show
“FINAL CLEANING”
. Pellet loading is
stopped, turning off the gear motor. The flue gas extractor speed increases to maximum and then switches off after the
cooling of the appliance, displaying
"OFF”
.
Changing the room and water temperature
- Heating system Water Temperature
To modify the water temperature, simply select
“SET H2O”
by pressing button 1. Now use buttons 1 and 2. During this
operation, the display will appear as in the following picture.
Set
!
1
2
3
4
5
6
After setting the desired value, press button 4 or wait a few seconds to confirm.
During the working mode the appliance enters
“Economy mode operation”
when that temperature value is reached
(See
“Working mode”
)
.
70°
C
SET
H2O
