IV. Preliminary steps
1. The soundbar can be placed on a desktop or hang on the wall.
2. If you decide to mount the soundbar on the wall, determine the location and
mark the holes on the surface. To do so, check the soundbar hole spacing and
use the supplied brackets as template.
3. For gypsum or wooden walls, locate studs in the wall. You may use a stud
finder to determine the center of each stud.
4. Using an appropriately sized drill bit, drill a hole in the wall at each marking, and
insert the supplied anchors if installing the unit on a concrete or brick wall.
Note:
If installing the soundbar below a TV, align the center of the soundbar with
the center of the flat panel.
Caution:
Connect any external devices to the soundbar before mounting the
soundbar on the wall.
Before installing the soundbar, make sure it is turned off and unplugged.
Wall mount installation
Buttons
Press to toggle between the standby and active modes on the
device
Cancels the audio coming from the soundbar. Press it again to
unmute the speaker
Press to start and pause media. This feature is not available in
auxiliary mode
Press to select the source device connected via
Bluetooth
Press any of these buttons to select the source device connected
to the 3.5mm input jack
Press this button to select the source device attached to
the USB port
Press to lower the audio level coming from the soundbar
Press to increase the audio level coming from the soundbar
Press to go back to the previous track on your play list. This feature
is not available in auxiliary mode
Press to select the next track on your play list. This feature is not
available in auxiliary mode
1.
Power/Standby
button
2.
Mute
button
3. button
5.
Aux 1 and
Aux 2
buttons
8.
V+
button
7.
V-
button
6.
USB
button
4.
BT
button
9. button
Description
10. button