KLINGER Denmark A/S | Nyager 12-14 | DK-2605 Brøndby | +45 43 64 66 11 | [email protected] | www.klinger.dk
Ultrasonic Heatmeter
Operation Manual
33
Temperature Sensitivity Setting
When the delta temperature is less than the
sensitivity set, energy will not be accumulated. Set
the adjustable temperature range of 0
℃
~ 20
℃
. The
factory default setting is 0.2
℃
.
Select Specific Heat Options:
0.
CJ128 SHC
1. Other
Use “
↑
” and “
↓
” to switch.
M25
Power Down Correction Switch
With the function of power down automation
correction switch, the flow lost in an offline session
can be estimated and automatically adjusted. The
estimate is based on the average value, which is
obtained from flow rate before going offline and
flow measured after going online the next time,
multiplied times the time period that the meter was
offline. Select "ON" to use this function, select
"OFF" to cancel this function.
M26
K Factor
The K factor is used to modify the measurement
results. The user can enter a numerical value (other
than "1") according to the actual calibration results.