RPTR-OBA/734
Installation Manual
REV: B (04/25/2022)
35
8
Pneumatic Tubing Routing & Plumbing.
With all components located, you are now able to route the air tubing as desired & install onto the
compression / push-to-connect fittings as applicable.
Route the air tubing as desired to the different parts of the system. Use the below figure for proper
hookup & the following tips for routing & installation.
•
Tape off the exposed end of the air tubing so debris does not enter the line while you are
routing the tubing through the vehicle.
•
Use a heat gun to soften the ends of the air tubing to easily slide the tubing over the lip of
compression fittings.
•
Avoid routing the tubing through areas that move or are exposed to high heat.
Note: The compressor should already be plumbed into the tank at this point. If not, do so now.
Figure 42- Air Tubing Plumbing
Once air tubing is installed onto primary air horn driver, reinstall horn trumpets as
shown in the below figure & final tighten the hardware that retains the air horns.
Figure 43- Air Horn Trumpet Installation Order
END OF SECTION
