CANX3-KIT
Installation and Operation Manual
PG 28/44
REV: A (9/4/2020)
8.8.
Bench Assemble Compressor Bracket and Rubber Bushings
8.8.1.
Insert Rubber Bushings and Brass sleeves into Compressor Bracket, as shown below in Figure 17 and
Figure 20
Figure 17 - Air Compressor Bracket with Rubber Grommets Installed
RUBBER BUSHINGS & BRASS SLEEVES FROM
COMPRESSOR FEET
INSTALL THIN SIDE OF BUSHING
THROUGH HOLE; THICK SIDE TOWARD
VEHICLE REAR
***Use slight amount of silicone grease to
facilitate insertion
INSERT BRASS SLEEVE INTO THIN SIDE
OF BUSHING (I.E.., FRONT SIDE)
