5 Operation
Display:
0
Start In i
after a few seconds
0
In i t-ok !
After clearing, by pressing SELECT , the recording mode will continue.
5.2.6
Data transmission to PC
Using the software KG 315 - K USB Pyroskop Control included with the infrared interface, it is easily possible
to read out the measured data. For this purpose the positioning pins of the infrared interface are inserted into
the positioning aids on the pyrometer.
Figure 4: Position of the infrared interface for data transfer
It is important to ensure that the chamfered side of the interface shows up. The USB connector is connected
to a free USB port on the PC.
The Software KG 315 - K USB Pyroskop Control is explained in a separate manual.
5.3
Configuration
5.3.1
Selection of values
The configuration menu is displayed from measuring mode by pressing CONF
and SELECT
simultane-
ously.
In this menu the SELECT
key switches to the next menu point. The selection of values can be done by
pressing the
+
or
–
key. The displayed value will be enlarged or reduced by one step.
If one of the two keys is pressed longer than two seconds a quick-count mode will be set to allow the change
of values more quickly.
By pressing the SELECT key the value will be stored in the correct limits and the next menu item is selected..
5.3.2
Parameters
1. Emissivity
The emissivity can be chosen between 0.1 and 1.00.
2. Maximum temperature
(only Classic Extended, Ways)
The maximum temperature can be set.
3. Minimum temperature
The minimum temperature can be set.
4. Energy saving mode
The time until energy saving mode is reached.
10
KG 315 - K USB
