I
nstalling the
A
ppliance
Bottom view
of the screws.
There
is
one set of screw holes in each
corner of the hob.
Slightly tighten a screw
(C) through the bracket
(B) so
that the bracket is attached to the hob, but so that you
can still adjust the position .
.
2 Carefully turn the hob back over and then gently lower
it
into the aperture hole that you have cut out.
.
3 On the underneath of the hob, adjust the brackets into
a
position that is suitable for your worktop.
Then fully tighten the screws
(C) to secure the hob
into
position.
(A) SEALING STRIP
(C) SCREW
(B) BRACKET
Remove the pan supports, the burner
caps
and
burner heads
and carefully turn
the
appliance upside down and place it
on a cushioned mat.
Take care that the Ignition
safety
devices and
igniters
are not damaged in
this operation.
2. Apply the sponge provided around the
edge
of
the appliance.
3.
1.
Do not leave a gap in the sealing agent or
overlap the thickness.
3ODFHWKHEUDFNHW
%RYHUWKHKROHVWKDWPDWFKWKHVL]H
7KLVZLOOPDNHLWGLI¿FXOWWRUHPRYHWKH
DSSOLDQFHIURPWKHDSHUWXUHLQIXWXUH
SDUWLFXODUO\LILWQHHGVWREHVHUYLFHG
Do not use a silicon sealant to seal the
appliance against the aperture.
17
