H
ow to
U
se the
A
ppliance
Automatic ignition with flame failure safety device
The appliance is fitted with a flame failure safety device on each burner, which is designed
to stop the flow of gas to the burner head in the event of the flame going out.
To ignite a burner:
o
o
o
o
o
o In case of power failure, the burners can be lit by carefully using a match.
Press in the control knob of the burner that you wish to light and turn
it
anti-
clockwise to the maximum position.
K
eep the control knob depressed,
and
the automatic ignition for
the
burner will
operate.
H
old down the control knob for 15 seconds after the flame on
the burner
has lit. If
after 15s the burner has not lit, stop operating the
device and wait at least 1 min
before
attempting a further ignition of
the burner.
After this 15-second interval, to regulate the flame continue
turning the
control knob
anti-clockwise until the flame is at a suitable level.
The operating
position MUST be at
a position between the maximum and
minimum position.
To switch the burner off, turn the control knob fully clockwise to the gas
off
position.
In case the appliance fails to operate correctly, contact the authorised service provider in your
area.
11
