Kleenmaid DW17W, Instructions For Use And Warranty Details

Page: 12 / 19

• 12 •
INSTALLATION
Building the free-standing machine in
If you install the dishwasher built-in under an existing worktop, you must attach it with the front
bracket to a fixed worktop . If installing in this way, proceed as follows:
- Remove the worktop by unscrewing the 2 screws under the edge of the upper plate.
- Fit the dishwasher into its housing.
- Adjust the height of the feet if necessary (fig. 4).
- Use two screws to fasten the front bracket to the kitchen worktop, so as to make your dishwasher
fast.
For safety reasons Kleenmaid recommends that your dishwasher is not installed directly
below a cooktop. If installation is carried out in this manner your warranty may be void.
Voltage : 240 V – 50 Hz – Fuses : 10 A
Power : 2300 W
Capacity : 14 place settings Water pressure : 3 psi/21 kPa min
100 psi/690 kPa max
Water evacuation pipe height : 60 cm - 1 m
TECHNICAL CHARACTERISTICS
COMPARATIVE TESTS ACCORDING TO : AS/NZS 2007 : 98 (Fig. 8-10-12)
With the “Condenser Drying” touch activated
Programme 4 “Fragile wash 40°C”
• Rinse aid dispenser setting on : 3
• Quantity of washing product : 10+40 g.
• For the determination of Drying Index the door of the dishwasher was opened approximately
240mm at the end of the program for 30 minutes.
NOTE :
These measurements are shown
without worktop fitted. If installing with
worktop fitted :
1 - To overall height add 32mm
2 - To overall width add 4mm
3 - Overall depth of worktop from rear
to front corners = 581mm
4 - Overall depth of worktop from rear
to centre front 600mm
Soundproofing apron (Fig 15)
See page 16