Removing/mounting the
telescopic
guides
Y
ou will find
telescopic
guides installed. To remove them,
release the lateral support guides as described in the
“REMOVAL
/
MOUNTING
OF
THE LATERAL GUIDES” paragraph.
Holding the lateral guides vertically on a flat surface, release
the lower part of the runner, making it turn as indicated in figure
1. At this point, the runner can be removed completely from its
housing.
Fig. 1
Fig. 2
To reposition the
telescopic
guide again on the relevant
supports, position the upper attachments on the rod of the
lateral guide, press the runner downwards in a way that it is
tightly coupled and exert pressure as demonstrated in figure 2
until the runner is tightly fastened to the support.
Replacing the oven light bulb
To prevent electric shocks and/or damage to persons, read and
follow the procedure given below:
ATTENTION
Before replacing the bulb make sure that the appliance
is
switched
off and the mains electricity has been
disconnected
to avoid the possibility of electric shock.
Ensure that the oven and the light bulb are cold and then
remove the protection cover
A.
Do not touch the hot bulb with a damp cloth as the bulb may
break. Replace the light bulb with another suitable one of 25
W for 220 - 2
4
0
V
with attachment type E14, suitable for
high temperatures.
Should the protection cap be damaged or broken, do not use the
oven until the cap has been replaced or re-inserted correctly
and safely.
Instructions for installation
The purchaser is responsible for installation. Assistance
provided by the manufacturing company due to an incorrect
installation will not be included in the warranty.
The installation and technical assistance must only be
performed by qualified
persons,
following the instructions.
Incorrect installation, maintenance, assistance and use
can cause serious damage/injury to persons or objects.
1
4
