16
KLAXON Mobility GmbH - ENG
KLICK Power Limited Edition Manual (ENG) - rev.1.0 of 2020.07.07
CAUTION
Always apply the correct force to the brakes. Pressing too suddendly and too forcefully the Tetra handlebar may cause
the front wheel blockage. This will increase the braking distance and compromise the overall stability.
12.4 TURNING OFF AND RELEASING FROM THE WHEELCHAIR
To perform the operation properly, carefully follow the following instructions.
Stop the wheelchair on a flat surface.
Apply the brake on the wheelchair.
Turn off the display by pressing and holding the “
POWER
” button for 5 seconds.
Firmly push the quick release lever of the CONNECTOR TETRA sideways to the right. By doing so, the lower pin is automatically
released and the KLICK disengages from the CONNECTOR, lowering the wheelchair and bringing the front wheels in contact with the
ground (Figures 35 and 36).
At this point the upper pin will already be pulled out the front hook of the CONNECTOR; release the wheelchair’s brakes and push
yourself back to move away from the KLICK device (which in the meantime will remain upright thanks to its KICKSTAND - Figure 37).
Remove the CONNECTOR, pulling the Velcro grip upward and forward (Figure 38).
DANGER
During the KLICK release operation, pay attention to not endanger the top parts of your body (fingers, hands, arms)
as they could be affected by the sudden movement of the handlebar (or other parts of the device) if it is released too
quickly. To avoid this danger, after pressing the release button, gently release the handlebar by lowering the wheelchair
gradually.
13. CLEANING
Regularly cleaning the entire device makes it last longer and work better.
We recommend:
To switch the device off and to disconnect the battery charger before cleaning it.
To not use abrasive cleaning agents, detergents and high pressure cleaners.
To clean the device with a soft, damp cloth.
To dry the unit thoroughly after using it out in the rain.
In case the device is dirty, to soften the dirt and to remove it as soon as possible; then dry the device carefully.
To clean all the outside of the device at least once a month and after each ride on muddy terrains.
To be careful not to wet the electrical parts (battery, display, motor).
To not wash the parts under running water
To dry the parts immediately after washing by using a soft cloth.
If the electrical parts get wet, let them dry and do not use the device until they are completely dry.
14. SERVICING
KLICK devices must be serviced regularly, to ensure safe, reliable and efficient operation.
KLAXON is not responsible for any damage caused by non-maintenance or by insufficient maintenance. In such cases the warranty may be
voided.
Unscheduled maintenance can be carried out only by technicians authorised by KLAXON’s Technical Support Service.
Klick devices must be serviced/maintained only by KLAXON’s Dealer.
Do not remove any component from the device. Only Klaxon dealers can remove components from Klick devices.
The only component that can be removed by the user is the battery.
NOTE
Please contact a Klaxon Dealer to know whether a spare part is available or not.
14.1 PERIODICAL MAINTENANCE
We recommend the following regular maintenance:
At least once a month, check the tyre inflation pressure; a flat tyre affects the vehicle’s smooth ride, its safety and its power consumption.
The tyre of a Klick devices must be inflated to 2.7 bar.
CAUTION
Be careful when using high pressure air to inflate the tyre.