17
KLAXON Mobility GmbH - ENG
KLICK Power Limited Edition Manual (ENG) - rev.1.0 of 2020.07.07
At least once a month, check the tyres wearing. To replace an inner tube or a tyre, contact an authorised KLAXON technician.
At least once every two months, check the tightness of all screws and fasteners.
At least once a month, check the tightness of the fixing nuts of the wheels’ pins with a torque wrench calibration at 40Nm.
Before each use, check proper operation of the accelerator and brakes: any replacement of parts subject to wear (brake pads, discs,
brake system in general) should be carried out only by authorised KLAXON technicians. The vehicle should also be checked whenever
you feel the braking power has decreased.
Check the condition of the battery, before each use. To replace the battery, and any other electrical component, contact only authorised
KLAXON technicians.
Have a KLAXON qualified technician overhaul the entire device at least once a year, and/or whenever a malfunction
occurs.
DANGER
The device should be checked by a Klick Dealer whenever you feel that the braking power has decreased.
14.2 MALFUNCTIONS
If you encounter a malfunction during use of the KLICK device, contact KLAXON or of its authorised resellers.
Malfunction found
Possible cause
Corrective action
The device does not turn on
The battery is empty
Recharge the battery
The battery is positioned improperly
Check the position of the battery by removing it and
inserting it again, making sure that the electrodes
are inserted in the appropriate spaces.
General problems
Contact an authorised KLAXON service centre
It vibrates excessively during use
Loose screws
Contact an authorised KLAXON service centre
The Klick is not manoeuvrable
The front tyre is flat
Inflate tyre to 2.7 bar
The front tyre is punctured
Contact an authorised KLAXON Dealer
The display lights up but the device
does not move
Disconnected plug
Contact an authorised KLAXON service centre
You have problems coupling the
traction unit to the connector
The connector is not adjusted properly
Contact an authorised KLAXON service centre
You have problems attaching the
connector
There is dirt inside the coupling seat in
the crossbeam
Clean the surfaces of the seat in the crossbeam and
of the mounting system in the connector
You have problems attaching the
connector
The interlocking balls do not retract
when pulling the lever
Contact an authorised KLAXON service centre
Wheelchair front wheels touch the
ground
The Klick coupling is mounted too low
Contact an authorised KLAXON service centre
KLICK is noisy when in use
The fender touches the wheel while
moving
Make sure your feet are in a position that does not
interfere with the fender of the device
Reposition the fender, putting it back into place.
The brake pads touch the disc when
reversing
Contact an authorised KLAXON service centre
Do not operate the Klick device whenever it behaves abnormally. Immediately contact a Klaxon Dealer
14.3 RACE BATTERY (11 AH)
The RACE battery (48 V X 11 Ah) is box-shaped and secured to the connection with a latching system (Figure 42).
On the side of the battery, there are markings along which some LEDs show the current charge level. Pressing the button, the LEDs will show
the approximate charge level, in four levels (20%-50%-80%-100% - Figure 43).
The key, placed on the right side of the battery, can be used to remove the entire unit from the device; by turning it 180° anticlockwise, the
battery is released and it can be removed by pulling it upward (Figures 44 and 45).
