Instruction
manual
K
18
page
11
_______________________________________________________________________________________________________________
3.1. Operation of the unit
First you have to select the right dies (Pos.-No 4) for the intended application.
Attention
Don’t use the tool without dies.
The necessary hand forces to perform a proper crimp can be adjusted with the telescope
handles. To do that you have to loosen the screws (Pos.-No. 2), pull the handles out and
lock them again with the screws.
The dies will be inserted consecutively into the C-type crimping head. Then the
connecting material must be positioned in the crimping head.
A crimping process is terminated when the dies contacted each other.
After the crimping process has been finished the tool has to be opened and the connecting
material can be removed from the C-head.
Instruction
manual
K
18
page
11
_______________________________________________________________________________________________________________
3.1. Operation of the unit
First you have to select the right dies (Pos.-No 4) for the intended application.
Attention
Don’t use the tool without dies.
The necessary hand forces to perform a proper crimp can be adjusted with the telescope
handles. To do that you have to loosen the screws (Pos.-No. 2), pull the handles out and
lock them again with the screws.
The dies will be inserted consecutively into the C-type crimping head. Then the
connecting material must be positioned in the crimping head.
A crimping process is terminated when the dies contacted each other.
After the crimping process has been finished the tool has to be opened and the connecting
material can be removed from the C-head.
