45
EN
Efficiency boosting
This appliance is equipped with “energy efficiency boosting” function. By filling 3 litres
of water into the water tank on the side, energy efficiency can be increased.
The principle is as follows: When the appliance is in operation, the condenser becomes
hot. If you fill water into the water tank on the side after one hour of operation, the
condenser is cooled and the appliance uses less energy.
Note:
Do not fill the water tank higher than the 3-litre mark, otherwise the “Water
tank full” indicator lights up red and the appliance stops operating. If this happens,
drain off some water until the indicator light goes out. The appliance should then
continue normal operation.
Important notes
1. To prolong the life of the compressor, wait at least 3 minutes after switching off the
appliance before switching it on again.
2.
The cooling system is deactivated when the ambient temperature is lower than
the set temperature. The fan continues to run at the speed you set. If the ambient
temperature rises higher than the set temperature, the cooling system is reactivated.
3. This appliance has an ANTI-FROST function. If the heating function is used at low
temperatures, the heating function may stop to defrost the appliance. The heating
function will then continue as normal.
1.
Remove the water
tank on the side of
the appliance.
2. Fill the water
tank (max.
3 litres).
3.
Put the water
tank back into the
appliance.
