Klarstein 10035410, Manual

Page: 52 / 56

52
EN
Problem Possible Cause Prevention / Solution
Burner will not light using
ignitor. Electrical issues:
Electrode cracked or
broken; ”sparks at
crack”.
Replace electrode.
Electrode tip not in
proper position. Tip of electrode should be
pointing toward port hole in
burner. The distance should
be 1/8” to 3/16”. Adjust if
necessary.
Wire and/or electrode
covered with cooking
residue.
Clean wire and or electrode
with rubbing alcohol and
clean swab.
Wires are loose or
disconnected.
Reconnect wires or replace
electrode/wire assembly.
Wires are shorting
(sparking) between
ignitor and electrode.
Replace ignitor wire.
Push button sticks
at bottom sparking
between ignitor and
electrode. Replace ignitor
Wire insulation might be
broken.
Inspect wire insulation and
proper connection. Replace
wires if insulation is broken.
Burner will not match
light. See ”Gas issues” on
previous page.
See instructions for lighting the
grill in the “Operation” section
of this manual.
Improper method of
match-lighting.
Sudden drop in gas flow
or low flame. Grease buildup. Clean burners and inside of
grill/firebox.
Excessive fat in meat. Trim fat from meat before
grilling.
Excessive cooking
temperature.
Turn the knobs anticlockwise
to a lower setting.