Change the main grill burner valves injectors
16
Change the Side burner injectors
1. Remove the side burner grates.
2. Remove the burner caps. The caps are interlocked
to the burner base. Twist and lift the burner caps to
remove.
3. Use 10 mm socket and wrench or 10 mm nut
driver to remove the brass injectors from inside the
burner base.
4. Use 10 mm socket and wrench or 10 mm nut
driver to install the new injectors supplied with this
kit.
NOTE:
The number is stamped on the injector for
identification.
5. Repeat the procedure for the other burner.
6. Replace the burner top and caps. Align the notches
in the bottom of the burner top with the tabs on
the burner base and twist until the burner top is
seated on the burner base. You will feel it drop into
the deep notch.
A
Burner top notches
B
Burner base tabs
7. Replace the side burner grates
Change the Rotisserie-infrared burner injector(s)
1. Remove the access cover and screw at the back of
the grill hood with a Phillips screwdriver.
2. Use Phillips screwdriver to remove 2 screws
holding the spider guard to the burner.
A
Spider guard
B
Two screws
3. Use 10 mm wrench to remove the brass injector
located at the end of the supply pipe.
4. For model with 1 rotisserie burner:
Install injector see the chart on page 13 for correct
injector size to the end of the supply pipe. Use 10
mm wrench to tighten.
For models with 2 rotisserie burners:
Install injector supplied with the kit to the end of
the supply pipe. Use 10 mm wrench to tighten.
NOTE:
The injector number is stamped on the
injector identification.
5. Replace the spider guard and secure with the two
screws removed in Step 2.
6. Repeat the procedure for each rear burner.
B
A
A
B
