![background image](http://html.mh-extra.com/html/kitchenaid/kfgg500ebl/kfgg500ebl_user-instructions_198247007.webp)
7
3.
Preheat the griddle for 5 minutes. Preheating the griddle slowly
will ensure even heat distribution and will avoid warping the
griddle.
4.
For preheating and cooking, set the front burner to the lowest
heat setting and the rear burner to medium-high heat for best
performance.
NOTE:
The griddle may also be used on the left side grate. For
best results, the rear burner setting should be set to Medium-
Low or Medium, and the front burner setting should be set to
Low.
To Clean the Griddle:
1.
Let the griddle cool, and then empty the drip tray.
2.
See the “General Cleaning” section for cleaning instructions.
3.
Store griddle in a cool dry place.
Sealed Surface Burners
A. Burner cap
B. Burner base
C. Alignment pins
D. Igniter electrode
E. Gas tube opening
IMPORTANT:
Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Burner Cap:
Always keep the burner cap in place when using a
surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
“General Cleaning” section.
Gas Tube Opening:
Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil,
and do not allow spills, food, cleaning agents or any other material
to enter the gas tube opening. Keep spillovers out of the gas tube
by always using a burner cap
.
B
A
A. 1 to 1¹⁄
2
" (2.5 to 3.8 cm)
B. Burner ports
Burner Ports:
Check burner flames occasionally for proper size
and shape as shown in the previous illustration. A good flame is
blue in color, not yellow. Keep this area free of soil and do not
allow spills, food, cleaning agents or any other material to enter
the burner ports.
To Clean:
IMPORTANT:
Before cleaning, make sure all controls are off and
the oven and cooktop are cool. Do not use oven cleaners, bleach
or rust removers.
1.
Remove the burner cap from the burner base and clean
according to “General Cleaning” section.
2.
Clean the gas tube opening with a damp cloth.
3.
Clean clogged burner ports with a straight pin as shown. Do
not enlarge or distort the port. Do not use a wooden toothpick.
If the burner needs to be adjusted, contact a trained repair
specialist.
4.
Replace the burner cap, making sure the alignment pins are
properly aligned with the burner cap.
A
B
A. Incorrect
B. Correct
5.
Turn on the burner. If the burner does not light, check cap
alignment. If the burner still does not light, do not service the
sealed burner yourself. Contact a trained repair specialist.
Burner Size
Select a burner that best fits your cookware. See the following
illustration and chart.
(
SR
)
(
SR
)
(
AUX
)
Large
(UR)
Large
(UR)
Burner Size
Recommended Use
Small (Auxiliary)
■
Low-heat cooking
■
Melting chocolate or butter
Medium (Semi Rapid)
■
Multipurpose burner
Large (Ultra Rapid)
■
For large cookware
D
E
C
B
A
Alignment:
Be sure to align the gas tube opening in the burner
base with the orifice holder on the cooktop and the igniter
electrode with the notch in the burner base.
NOTE:
Each round burner base is marked with a letter indicating
the burner size.