![background image](http://html.mh-extra.com/html/kitchenaid/kesc300h-bl/kesc300h-bl_technical-education_1973009031.webp)
4-5
REMOVING AN ELEMENT & LIMITER AND
THE HOT SURFACE INDICATOR ASSEMBLY
1.
Unplug range or disconnect power.
2.
Remove the control panel from its
subchassis, (see page 4-2 for the proce-
dure), and rotate it forward onto the cooktop
glass.
3.
Remove the five screws and flat washer
from the control panel subchassis.
4.
Move the control panel back into place
over the chassis, then lift the front of the
cooktop assembly, and prop it up with a
piece of board so that you can access the
components (see the photo at the top of
the next column).
CAUTION:
Be careful
that the cooktop does not accidentally fall.
2 Screws
2 Screws
Screw & Flat Washer
5.
To remove an element and limiter:
a) Remove the wires from the element
and limiter terminals.
b) Remove the screw, or pull the end of
the retaining rod out of the bracket, and
remove the element and limiter from
the bottom of the cooktop.
Continued on the next page.
Subchassis
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
Retaining Rod
(Pull Out)
Retaining
Rod Screws
Summary of Contents for KESC300H BL
