![background image](http://html.mh-extra.com/html/kitchenaid/8301169/8301169_installation-instructions-manual_198024007.webp)
7
8.
Remove cardboard or hardboard
from under range.
9.
Attach the backguard or island trim
as required for your installation.
Attachment screws are in the literature
package.
10.
Slide range completely back so
anti-tip bracket is over rear brace of
range.
11.
Make gas connection. Assemble
flexible connector from gas supply pipe to
pressure regulator located in the middle
front of the range. Apply pipe-joint
compound made for use with L.P. gas to
the smaller thread ends of the flexible
connector adapters. Attach one adapter
to the pressure regulator elbow and the
other adapter to the gas shutoff valve.
Tighten both adapters.
13.
Leak testing of the appliance
shall be conducted according to the
following instructions:
Use a brush and liquid detergent to test
all gas connections for leaks. Bubbles
around connections will indicate a leak. If
a leak appears, shut off gas valve
controls and adjust connections. Then
check connections again. Clean all
detergent solution from range.
14.
Put a burner cap on each
burner base. Place burner grates over
burner bases and caps.
If your model has only surface burners
(no grille or griddle), go to “Check the
operation of the surface burners, grille
and griddle” on Page 9.
If your model was shipped with a grille or
griddle, go to “Installing the grille or
griddle” on Page 8 to complete the
installation.
15.
Turn on power supply. “PF”
should appear in the clock display. (Refer
to your Use and Care Guide for
instructions on using the electronic
control.)
12.
Open manual shutoff valve in
gas supply line. Wait a few minutes for
gas to move through the line.
attaching the
backguard
attaching the island
trim
center hole
not used
3 front screws
(4 rear screws required
but not shown)
use pipe-joint
compound
flexible
connector
1/2" flare union
adapter
manual gas
shutoff valve
1/2" to 3/4" gas
pipe
a 1/2" male pipe thread is needed for connection
to pressure regulator female pipe threads
regulator
gas supply
line
shutoff valve
“open” position
to range
burner cap
burner
base
ignitor
electrode
gas tube
opening