6
ASSEMBLING THE STAND MIXER
Attaching/removing the flat beater, wire whip, or dough hook
1
To attach accessory: Check to make
sure that the Stand Mixer is unplugged
and the speed control is turned to “O”.
2
Hold the locking lever in the unlock
position and tilt motor head back.
3
Slip accessory onto beater shaft and
press upward as far as possible. Then,
turn accessory to the right, hooking
accessory over the pin on the shaft.
NOTE: Motor head should always be in lock position when using the Stand Mixer.
Lifting/lowering the motor head
1
To lift motor head: Push the locking
lever to the unlock position and lift
the head. Once lifted, the lever will
automatically go back in lock position to
keep the head lifted.
2
To lower motor head: Push the
locking lever to unlock and gently bring
the head down. The locking lever will
automatically go back in lock position
when the head is down. Before mixing,
test lock by attempting to raise
motor head.
ASSEMBLING THE STAND MIXER
W11090745A_ENv14.indd 6
2/27/17 2:58 PM
