KisanKraft
®
Shoulder Mounted Baffle Type Reaper
KK-SBC-4502, KK-SBC-3804
: www.kisankraft.com
: +91.80.22178200
Page 20 of 32
3.
Push the primer pump several times until
overflown fuel flows out in the return tube.
4.
Move the choke lever to the closed position.
Note:In the adjacent figure,
(1)
Choke lever
(2)
Closed position
(3)
Open position
OP3
5.
Set the ignition switch to the “start” position.
While pulling the throttle lever, push the
throttle set button, and release the throttle,
then the throttle lever is into the
“Start
position.
Note:In the adjacent figure,
(A)
Stop position
(B)
Start position
6.
While holding the unit firmly, pull out the
starter rope quickly until engine fires.
IMPORTANT
Avoid pulling the rope to its end or returning it
by releasing the knob. Such actions can
cause starter failures.
7.
Move the choke lever to the open position (OP2). And pull out the starter rope
quickly to restart engine. (OP4)
8.
Allow the engine to warm up for several minutes before starting operation.
NOTE
1.
When restarting the engine immediately after stopping it, leave the choke open
(OP2) and push the primer pump several times (OP4).
2.
Over choking can make the engine hard to start due to excess fuel. When the
engine failed to start after several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
Stopping the Engine:
1.
Release the throttle lever and run the engine for a half minute.
2.
Shift the ignition switch to the STOP position. (OP3)
NOTE
Except for an emergency, avoid stopping the engine while pulling the throttle lever.
KisanKraft
®
Shoulder Mounted Baffle Type Reaper
KK-SBC-4502, KK-SBC-3804
: www.kisankraft.com
: +91.80.22178200
Page 13 of 32
6.
Never touch the muffler, spark plug, or other metallic
parts of the engine while the engine is in operation or
immediately after shutting down the engine. Doing so
could result in serious burns or electrical shock.
If Someone Comes
1.
Guard against hazardous situations at all times. Warn
adults to keep pets and children away from the area. Be
careful if you are approached. Injury may result from
flying debris.
2.
If someone calls out or otherwise interrupts you while
working, always be sure to turn off the engine before
turning around
Maintenance
1.
In order to maintain your product in proper working
order, perform the maintenance and checking
operations described in the manual at regular intervals.
2.
Always be sure to turn off the engine before performing
any maintenance or checking procedures.
WARNING
The metallic parts reach high temperatures immediately
after stopping the engine
.
3.
Under no circumstances should you ever take apart the
product or alter it in any way. Doing so might result in
the product becoming damaged during operation or
the product becoming unable to operate properly
Handling Fuel
1.
The engine of the product is designed to run on a mixed
fuel which contains highly flammable petrol. Never store
cans of fuel or refill the tank of the unit in any place
where there is a boiler, stove, wood fire, electrical
sparks, welding sparks, or any other source of heat or
fire which might ignite the fuel.
2.
Never smoke while operating the unit or refilling its fuel
tank.
3.
When refilling the tank, always turn off the engine and
allow it to cool down. Take a careful look around to make
sure that there are no sparks or open flames anywhere
nearby before refueling.
4.
Wipe spilled fuel completely using a dry rag if any fuel
spillage occurs during refueling.
5.
After refueling, screw the fuel cap back tightly onto the
fuel tank and then carry the unit to a spot 10feet (3m) or
more away from where it was refueled before turning on
the engine.
