KisanKraft
®
Shoulder Mounted Baffle Type Reaper
KK-SBC-4502, KK-SBC-3804
: www.kisankraft.com
: +91.80.22178200
Page 24 of 32
Refilling Trimming Line:
1.
For replacement line, use a diameter
of 2.4mm (.095in). The spool is
capable for a line up to 6m (20ft) on
the 10cm (4”) head. Avoid using a
larger line as it may cut down the
trimming performance.
2.
Pinch the slotted area on the both
sides of the spool housing to unhook
the bottom cap.
3.
Take out the spool and pull off the old
line. Put one end of new line through
the spool holes and pull it until the
length is equal between each part of
the line.
4.
Wind up the line in the correct
direction as indicated on the spool.
5.
Hook each end of the line in the slot
on the edge of the spool, and then
put the ends through the eyelets on
the housing. Make sure that the
spring and the washers are in place.
6.
While holding the spool against the
housing, pull the line ends to release
them from the slot.
7.
Line up the slot on the bottom cap
with the hook on the housing, press
the cap against the housing until it
clicks.
Air Filter:
The air filter, if clogged, will reduce the
engine performance. Monthly check and
clean the filter element in warm, soapy
water as required. Dry completely before
installing. If the element is broken or
shrunk, replace with a new one.
Note: In the adjacent fig:
(1) Air Filter
Fuel Filter:
When the engine runs short of fuel supply, check
the fuel cap and the fuel filter for blockage.
Note: In the adjacent fig:
(1) Fuel Filter
KisanKraft
®
Shoulder Mounted Baffle Type Reaper
KK-SBC-4502, KK-SBC-3804
: www.kisankraft.com
: +91.80.22178200
Page 9 of 32
Safety Instructions
1.
Read this manual carefully until you completely
understand and follow all safety and operating
instructions.
2.
Keep this manual handy so that you may refer to it
later whenever any questions arise. Also note, if
you have any questions which cannot be
answered herein, contact the dealer from whom
you purchased the product.
3.
Always be sure to include this manual when
selling, lending, or otherwise transferring the
ownership of this product.
4.
Never allow children or anyone unable to fully
understand the directions given in the manual to
use the machine.
Working Condition
1.
When using the product, you should wear proper
clothing and protective equipment.
(1) Helmet
(2) Ear protectors
(3) Protection goggles or face protector
(4) Thick work gloves
(5) Non-slip-sole work boots
2.
And you should carry with you.
(1) Attached tools and files
(2) Properly reserved fuel
(3) Spare blade
(4) Things to notify your working area (rope,
warning signs)
(5) Whistle (for collaboration or emergency)
(6) Hatchet or saw (for removal of obstacles)
3.
Do not wear loose clothing, jewelry, short trousers,
sandals, or go barefoot. Do not wear anything
which might be caught by a moving part of the unit.
Secure hair so it is above shoulder length.
