KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-6320
This warranty is null & void, if you fail to register the warranty with KisanKraft by
sending the KisanKraft Copy with dealer’s stamp.
: +91.80. 6835 7800
Page 16 of 28
Easy start device:
Fast and continuous oblique balanced position can be activated by starting the
handle. When you return, hold the starting handle tightly so that the pull rope can be automatically and
evenly returned to the original position. Do not suddenly let go, so as not to start the handle to rebound
quickly, which may cause damage to the boot assembly.
Note:
When the start is not at that time, if the cylinder inhale too much fuel will cause the phenomenon of
flooding and it cannot start, you can go down the spark plug with the thumb of the left hand to hold the
spark plug hole, pull the starter for 5-6 times continuously to discharge the oil, then install the spark
plug, and operate according to the correct starting method
Attention:
strictly prohibit the use of pure petrol as fuel, pure petrol will cause overheating of petrol
engine and damage.
Pay special attention to:
No firework is prohibited in handling, refueling, or storing fuel, and it can only be mixed and stored in
qualified petrol containers.
Most petrol engine failures are directly or indirectly caused by fuel contracts.
Adjustment of petrol engine
Every petrol engine must undergo strict commissioning and inspection before going out of factory.
Climate conditions or altitude differences may affect the performance of petrol engines, according to the
actual use of minor adjustments.
1.
The adjustment of the gap between the magnetic flywheel (F2-1)
The gap between the magnetic flywheel and the high-pressure package should
be between
0.25=0.4mmm. If it is not in this range, you can loosen two M5*25-cylinder screws and replaced by a
0.25=0.4mm tape or a coke bottle between the magnetic flywheel and the high-pressure package,
and the high-pressure package can be adjusted to ensure the gap at 0.25= 0.4mmm and tighten two
screws.
