Chainsaw-Petrol
KK-CSP-5920/6020/6522/7524
: www.kisankraft.com
: +91.80. 22178200
Page 43 of 80
Reinstall the starter pulley, tension the recoil spring, fit the fan housing and secure in position
with the screws.
Air Filter
The air filter must be regularly cleaned to remove dust and dirt in order to avoid:
Carburetor malfunctions
Starting problems
Loss of engine power
Unnecessary wear to engine parts.
Excessive fuel consumption.
Remove the air filter after taking off the air filter cover.
Clean the filter by brushing or shaking it.
The filter can be cleaned more thoroughly by washing
it in water and detergent.
An air filter that has been in use for a long time cannot
be cleaned completely. The filter must therefore be
replaced with a new one at regular intervals.
Spark Plug
The spark plug condition is influenced by:
Incorrect carburetor adjustment.
An incorrect fuel mixture (too much or incorrect type of oil).
A dirty air filter.
These factors cause deposits on the spark plug electrodes, which
may result in operational problems and starting difficulties.
If the machine is low on power, difficult to start or runs poorly at idle
speed:
Always check the spark plug first before taking any further action. If
the spark plug is dirty, clean it and check that the electrode gap is
0.5mm to 0.7mm. The spark plug should be replaced after about a
month in operation or earlier if necessary.
Note!
Always use the recommended spark plug type! Use of the
wrong spark plug can damage the piston/cylinder.
Lubricating the bar tip sprocket
Lubricate the bar tip sprocket each time you refuel. Use the special
grease gun and a good quality bearing grease.