2-Stroke Petrol Engine
: www.kisankraft.com
: +91.80. 22178200
Page 60 of 68
PRECAUTIONS DURING OPERATION
After starting the engine, set the
throttle lever at the slow speed
position and warm up the engine
for approx. 2~3 minute. As the
engine worms up, the engine will
be accelerated smoothly.
Do not attempt to raise the engine speed abruptly immediately after the start
because the lubrication oil may not be distributed yet all over the engine.
If the throttle lever is turned to the fully opened position, the revolution speed
picks up to a considerably higher level, which could not only shorten the life of
engine but also cause trouble. It should be avoided to race the engine at high
speed under no load condition or raise the speed unnecessarily.
Before starting operation, make sure to inspect the engine in accordance with
the
“Inspection before starting the engine”.
Do not operate the engine at the indoor or a place with poor ventilation.
(Exhaust gas contains odorless and harmful carbon monoxide.)
Do not insert in or approach hands or foot at the moving or rotating sections.
Stop the engine immediately if it has been discovered any leakage of fuel or gas
from the carburetor, muffler, fuel tank, crankcase, cylinder or mating face at
respective sections. (Contact a dealer or service center for repair.)
Do not change the setting revolution speed of engine unnecessarily.
Be careful not to touch highly heated muffler or sections on the engine to avoid
possible risk of burn.
Do not operate the engine while withered grasses, leaves or other inflammable
substances are sticking in or around the muffler cover.
Do not touch the ignition plug cap or high-voltage cord during operation. (There
is risk of electric shock or physical injury.)
Do not operate the engine with the muffler or air cleaner cover removed
Summary of Contents for KK-BC2-JP30
Page 68: ......
