4
INSTALLATION
INSTALLATION
Extension Brackets (Optional)
■
Position the extension brackets to the wall markings made above.
■
The bracket tops must be aligned and level to one another.
■
Mount the extension brackets with screws through diagonal holes.
■
Attach the installation brackets to the extension brackets.
NOTE:
Installation brackets and center support brackets are attached to extension brackets with the included screws and nuts.
Ceiling Mount
For ceiling mounts, ensure that a 1-
3
⁄
4
" high, flat vertical surface is available for securing the installation brackets. The brackets will
be normally be screwed in place through the top holes, but see optional attachments below.
Mark the Bracket Positions
■
Center the headrail at the desired height. Use a pencil to lightly mark each end of the headrail on the mounting surface.
➤
Alternatively, measure the width of the headrail and use that width to mark the headrail end points.
■
Then mark
1
⁄
4
" from the headrail marks for the installation brackets.
Attach the Brackets
■
For normal ceiling mounts, screw through the top holes.
■
If brackets sides are also flat to wall, screw through top and side holes.
■
If brackets backs are flat to wall, screw through top and back holes.
Installing the Blind
With the installation brackets in place, the headrail may be mounted.
Open the Bracket Door Latches
■
Press up on the bracket bottoms while lifting the bracket doors open.
Mount the Headrail
■
Tilt the headrail slightly backwards to lower the back-side lip.
■
Slide the headrail into the brackets and push it all the way back.
■
The front lip of the headrail should hook to the center support lips.
Verify Headrail Lift
■
If the headrail moves left or right more than
1
⁄
8
", adjust.
➤
Use a flat head screwdriver to bend the end stiffener tabs out.
Close the Bracket Door Latches
■
Snap the door shut over the locking tab to secure.
