8
INSTALLATION
OPERATION
Problem
The blind height is too long.
Solution
For Cordless blinds, turn all the skew adjustment features clockwise to raise the entire bottom rail to the desired
height while lifting the weight from the bottom rail. There is an adjustment range of approximately 1-
1
⁄
4
”.
Removing the Blind (If Necessary)
■
Fully raise the blind.
■
To remove the valance with valance clips, see page 6.
■
Push up on the bottom end of the bracket to release the locking tab.
■
Grab underneath the headrail using both hands and carefully pull the blind out of the end brackets.
Cleaning Procedures
Like any fine furnishings, Kirsch
®
Faux Wood Blinds Collection should be cleaned regularly to keep them looking new.
Dusting
■
Dust regularly. Use a soft clean cloth, chemically-treated dust cloth, or dusting mitt. Lower the blind until it is full length, tilt
the slats almost all the way down, and dust. Then tilt the slats almost all the way up and dust. (Not closing the slats all the way
allows dusting where the slats overlap).
Vacuuming
■
Blinds may also be vacuumed. Use the brush attachment and tilt the slats up and down as described for dusting.
Damp Cleaning
■
To wipe your blinds, use a soft cloth or sponge. Use warm or cold water -
not
hot water. Place toweling on the floor or sill and
wipe the blind in sections.
IMPORTANT:
Kirsch does not recommend ultrasonic cleaning of wood blinds.
CARE
