5
INSTALLATION
INSTALLATION
Installing Components
With the blind properly mounted and in place, these optional components may now be attached. They include the hold-down
brackets and wand tilter (if ordered).
Attach the Hold-Down Brackets (optional)
■
Attach brackets to the window sill or an outside surface.
■
Lower the blind, align bottom rail pins to the hole or hook.
Attach the Hold-Down Brackets (optional 2" Cordless)
■
Lower the blind and place the hold down pins into the bottom rail end caps.
■
Mark the hold down bracket locations on the mounting surface.
■
With the brackets level, attach them using two screws.
Attach the Wand
■
Remove plastic sleeve from wand tip and slide it up the metal shaft.
■
Slip exposed wand hook through the tilter stem hole.
■
Push plastic sleeve back down and over the wand hook until secure.
■
Operate the wand by rotating between fingers.
Installing the Valance
Attaching the Magnetic Valance Clips to the Valance
The magnetic valance clips are adjustable for quick and easy valance attachment and have multi-position
valance adjustment capabilities.
■
To install the magnetic clips, lay the valance face down on a protected surface with the back side up.
■
Insert the clip dovetail into the valance groove and twist the clip until it is straight with the clear tabs
at the top of the valance.
➤
There are at least two clips per valance. For valances narrower than 36", position clips 5-
1
⁄
2
" in from
the ends of the valance. For valances 36" or wider, position the clips 10" in from the ends of the
valance. Additional clips should be spaced evenly between the two end clips.
Valance Width
# of Valance Clips
Up to 52"
2
42-
1
⁄
8
" to 82"
3
82-
1
⁄
8
" to 120"
4
120-
1
⁄
8
" to 150"
5
150-
1
⁄
8
" to 168"
6
