Kioti L3503, Owner'S Manual

Page: 70 / 128

5
-
L3503 / LK45
DraFt.ControL.LeVer PoSition.ControL
(1) Position Control Lever
(A) “UP” (C) “FLOAT”
(B) “DOWN ”
The position of an attachment can
be freely controlled within the range
of position control, using the lever.
An attachment will completely low-
er when the lever is in the floating
range.
(1) Draft Control Lever
(A) “UP” (B) “SHALLOW”
(C) “DEEP” (D) “FLOAT”
1. The draft control is used to do
draft work with an attachment, like
a plow, attached to the 3-point
linkage.
2. In the floating range, the attach-
ment will completely lower.
3. In the draft control range, the hy-
draulic unit will have a force to lift
the attachment. In this stage, it is
possible to do stable work without
slipping.
621O703A 621O702A
iMPortant

if.the.3-point.hitch.can.not.be.
raised.by.setting.the.hydraulic.
control.lever.to.the.“UP”.posi-
tion.after.long.term.storage.or.
when.changing.the.transmis-
sion.oil,.follow.these.air.bleed-
ing.procedures.
1..Stop.the.engine.
2..Set.the.hydraulic.control.le-
ver.to.the.“DoWn”.position.
and.start.the.engine.
3..operate.the.engine.at.low.idle.
speed.for.at.least.30.seconds.
to.bleed.air.from.the.system.

Do.not.operate.until.the.engine.
is.warmed.up..if.operation.is.at-
tempted.when.the.engine.is.still.
cold,.the.hydraulic.system.may.
be.dama.ged.

if.noises.are.heard.when.imple-
ment.is.lifting.after.the.hydrau-
lic.control.lever.has.been.acti-
vated,.the.hydraulic.mechanism.
is.not.adjusted.properly..Unless.
corrected.the.unit.will.be.dam-
aged..Contact.your.Kioti.dealer.
for.adjustment.
L3503_LK45-호주향-05.indd 32 2008-12-18 오후 1:52:56