KINZO 25C5030, Instruction Manual

Page: 49 / 132

25C5030
49
ENGLISH
Deburring (fig. A & B)
A grinding disc for deburring is used for removing burrs from metal
workpieces. A mandrel is used for mounting a grinding disc for deburring.
■ Place the mandrel (15) in the collet nut (6).
■
Loosen the screw on the mandrel.
■ Place a grinding disc for deburring (22) on the screw.
■ Place the screw on the mandrel and tighten it.
Drilling (fig. A & B)
A drill bit is used to drill holes in plastic, wooden and stone workpieces.
■ Place a drill bit (10) in the collet nut (6).
Routing (fig. A & B)
A router bit is used for grooving and for routing figures in plastic,
wooden and metal workpieces.
■ Place a router bit (13) in the collet nut (6).
Engraving (fig. A & B)
An engraving needle is used for engraving figures in metal workpieces.
■
Place an engraving needle (16) in the collet nut (6).
Grinding and sanding (fig. A & B)
A grinding stone is used for grinding metal, plastic, wooden and stone
workpieces. A sanding band is used for sanding wooden and plastic
workpieces.
■ Place a grinding stone (11) or sanding band with mandrel (12) in the
collet nut (6).
Replacing a sanding band (fig. B)
A sanding band must be replaced when showing signs of wear.
■ Remove the old sanding band from the mandrel.
■ Place the new sanding band (18) on the mandrel.
Using the grinding stone (fig. B)
■
Use the grinding stone (17) for removing burrs and other
irregularities on the workpiece.
25C5030_20.p7 04-06-2004, 15:29 49