19
OPERATION
F. Gear ShiftAdjustment
1. Loosen the bolts.
2. Press down the clutch pedal fully.
3. Operate the shift lever as to
change gearshift from 1 to 4 and
reverse smoothly.
4. First, tighten bolt 1 with
thread glue. Then second, tighten
bolt 2 with thread glue.
(
See Fig. 7
)
Figure 7
G. Break-in
The first month is most important in the life of your vehicle. Proper operation during this
break-in period will help assure maximum life and performance from your new vehicle.
The following guidelines explain proper break-in procedures.
1. After the engine starts, the engine is not allowed in high speed in the neutral gearshift.
2. Drive vehicle from stop to low speed slowly.
3. Avoid braking strongly.
4. Do not exceed the vehicle speed on the below schedule
H. Starting And Operating Instructions
a.
Before starting the engine, be sure that the driver is seated properly in the Go-Kart
and tighten the seatbelt.
b.
Testing the Go-Kart in a open place at the beginning to learn how to start, turn and
stop.
c.
Operate the Go-Kart slowly until you are familiar with it.
d.
The turning radius of this Go-Kart is small and agile, so the centrifugal force is very
high when turning at high speed. Slow down to a more controllable speed when turning
to prevent the Go-Kart from rolling over.
e.
To prevent vehicle from rolling over, be sure to only turn the vehicle at a slow more
controllable speed.
The speed of vehicle
The first 1000 km
Max speed in each gear
1st
Gear
15 km/h
2nd
Gear
25km/h
3rd
Gear
40 km/h
4th
Gear
70km/h
