10
Log Assembly for Models ZDV4224/ZDV4228
Log Assembly
1. Remove glass door by removing two (2) screws behind upper grills
and lifting door off bottom door retainer or unfasten latches if so
equipped.
2. Remove logs from carton and inspect.
3. Verify to see that ember plates (2 pcs) are between front and back
burner, air opening to top (as per diagram). The ember plates are
used to hold the glowing ember, thus simulating a glowing bed of
embers.
4. Place moon rock across opening at front burner, level with front
burner. Some moon rock can be on top of burner.
5. Place glowing embers on surface of front burner and surface of
ember plates.
Height on front burner 1/2” - 3/4”
Height on ember plates 3/4” - 1”
Do not cover back air opening on ember plates.
6. Place rear log on log shelf 1/2” away from back of fireplace.
7. Place front log over front burner, and resting against decorative
grate.
8. Place right and left logs across front and back log. Bark should be
to the outside, and right log as a knot.
9. Adjust right and left log so that black charred area sits between
front and rear log.
10.
Make sure that a space of at least 3/4” is maintained between
glowing ember and underside of front log ember bed area.
11. Front log should be centered on the log supports between the front
and rear burners. Pull log against the front of the supports.
12. Top logs can then be placed across the front and back logs in the
slots provided.
13. Purge lines and test pilot operation.
14. Replace glass door. The door must be installed before operating the
fireplace.
REAR LOG
LEFT LOG
RIGHT LOG
EMBER PLATE
FRONT LOG
LEFT CROSSOVER LOG
Part # 4200-253
REAR LOG
Part # 4200-252
FRONT LOG
Part # 4200-251
FRONT GRATE
FRONT BURNER
ROCK
MINERAL WOOL
LOG SET LOGC42
RIGHT CROSSOVER LOG
Part # 4200-254
BURNER
MOON ROCK
GLOWING
EMBERS
! EMBER PLATE AIR OPENING.
! DO NOT COVER UP !
! LOG MUST BE BROUGHT UP TO
FACE OF FENCE !
! EMBER PLATE AIR OPENING.
MUST NOT BE COVERED !
! OPENING BETWEEN GLOWING EMBERS
AND UNDERSIDE OF LOG. MUST NOT
BE LESS THAN 3/4 INCH !
MOON ROCK
GLOWING
EMBERS
Log Placement
Removal of Door
Units are equipped with screws and/or latches. To remove glass door,
either remove screws or unfasten latches and lift door off bottom door
retainer channel.
The following is a list of models and appropriate log sets that can be
used with each model. It is important that the appropriate log set is
used with the correct model in order for the appliance to work properly.
Appliance
LOGC42
LOGC43
LOGC44
LOGC60
ZDV4224N or LP
✔
✔
✔
ZDV4228N or LP
✔
✔
✔
ZDV4232N or LP
✔
Appliance/Log Reference Chart
