4
Ensure that 3 to 4 indicator lights are illuminated, or you may not be able to jump start the vehicle.
Insert the battery clamp plug completely into the jump starters starting port. The green and red
indicator lights will start to flash alternately.
Connect the RED (positive) clamp to the vehicle’s positive ( + ) terminal and connect the BLACK
(negative) clamp to the vehicle’s negative ( - ) terminal. The green and red flashes will continue
signalling. If only the red indicator light is on; check the clamps are connected correctly.
Once the indicator light flashes green and red while the clamps are connected to the vehicles
battery the car is now ready to be jump started.
Once the vehicle has started, disconnect the jump starter from the battery as soon as possible.
If the vehicle failed to start 3 times you can use the force start function by pressing and holding
the force start button on the clamps for 3 seconds. The indicator light will become a solid green,
attempt to start the vehicle within 30 seconds.
Once the car has started, remove the battery clamps from the car battery as soon as possible.
STARTING YOUR VEHICLE
Use either the provided or your own USB charging cable.
Connect the cable to either USB ports whilst connecting the other end to your device. If you are
using the provided USB charging lead ensure you select the correct connection for your device.
• DO NOT
charge more than 1 device at a time with the provided USB break out charging
cable.
• DO USE
both USB outlets at the same time if required.
Press the power button on the jump starter unit to begin charging your device
CHARGING MOBILE PHONES
Press and hold the power button for 3 seconds. The LED torch will then turn on.
Press the power button again to activate the strobe, SOS & off.
USING THE LED TORCH
You can charge your jump starter by:
1. Using the supplied 240V AC charger OR 2. Using the supplied 12V Cigarette plug lead.
CHARGING YOUR JUMP STARTER
OPERATION
