Kingfisher KI7300 Series, Operation And Maintenance Manual

Page: 60 / 66

QUICK REFERENCE GUIDE: KI7300C / 7700C Series Loss Test Set
KI7000 UM-5
-
58 -
MANUAL OPERATION
•
To remove interchangeable connector adaptor, press button
on rear of case and pull off adaptor. This may be easier with
a test lead attached.
•
To defeat auto power-off , hold [POWER] for 3 seconds at
turn on until ‘ON’ and ‘Perm’ are displayed
•
Low battery is indicated with a battery symbol
Power Meter Mode:
•
To enter , press [POWER METER]
•
To select operational wavelength, press [-/+]
•
To set reference, press [ABS/REL] and hold [SET REF] for 3
seconds. Meter displays about 0.00 dB R
•
To stop / start display update, press [HOLD]
•
If a test tone is detected, meter will display ‘Hz’
•
To toggle log / linear display mode, press [dB/W]
•
To display minimum and maximum recorded power for
selected wavelength, press [
] and [Max/Min]. Press [ ]
[Max/Min] and hold for 3 seconds to re-start recording.
Light Source Mode:
•
To enable source, select [Source].
•
To change wavelength , press [-/+]
•
To activate modulation, press [Mod]
•
To change modulation frequency, while source is active press
[
] [KHz] [-/+] [Set] or [Menu].
•
To change laser power level, while source is active press
[
] [Level] [-/+] [Set] or [Menu].
AUTOTEST OPERATION
•
To initiate Autotest, connect Power Meter section to Light
Source section and press [Autotest]
•
To show one wavelength only, scroll [-/+]. Press [Menu] to
exit.
•
Press [Hold] to hold / resume display update.
•
Autotest remains for 8 seconds after signal loss, to allow
quick connection change
•
To exit Autotest, remove test lead for >8 seconds, or on the
Light Source, press [MENU]