KI 7010B UM-11
28
QUICK REFERENCE GUIDE - KI7000B SERIES AUTOMATED VARIABLE OPTICAL ATTENUATOR
•
To install a connector adaptor, align the locating slot on the side of the adaptor with that on the instrument connector, and press it on.
Note: for KI7030B model, we specifically suggest never to use SMA POF connectors to avoid damaging the instrument, SC connectors
are preferred where viable, see note of caution in OPTICAL CONNECTOR (page 9) section of the user manual.
•
To remove an adaptor, press the release button on the back of the instrument and then pull off the adaptor. It may be easier with a test
lead in place.
•
To turn on the instrument for permanent operation, press [POWER] for 3 seconds
until ‘Perm’ is displayed at the top of the LCD.
•
To select calibration wavelength, press [
] [-/+] [SET].
•
To set attenuation level, press [-/+].
•
Low battery is indicated with a battery symbol.
STEP MODE
•
To operate in the step mode, simply press the [STEP] button. Pressing the [-/+] button will now increment attenuation according to the
previously set step size.
•
To view the current step size, press [SET STEP].
•
To adjust the step size, press [SET STEP] [-/+] [SET]. The unit will now operate in step mode using the new step value.
ABSOLUTE / RELATIVE DISPLAY MODE
•
To enter Relative display mode, set the attenuation level as required in Absolute display mode and press [ABS/REL].
•
If necessary, zero the display by pressing [REL].
•
To set the display to an arbitrary value (e.g. the absolute value displayed on a power meter), adjust the attenuation with the [-/+] button,
then press [SET].
Summary of Contents for KI 7010B Series
