King Quest VQ4100, Troubleshooting Manual

Page: 15 / 56

Page 13
Section 4
KING QUEST WITH UC1000 CONTROLLER
UC1000 Controller
If the KING Quest is connected with the UC1000 controller,
use this section. (If connected with a power injector, use section 3.)
The KING Quest can be configured to work with DIRECTV, DISH, or Bell TV (each service requires
paid programming subscription).
Use section 4.2 to verify, or change, the desired service configuration.
DIRECTV:
Choose your desired DIRECTV service option, then go to section 4.4 Operation.
DISH:
Choose your desired DISH service option, then go to section 4.3 receiver configuration.
After performing the check switch test, use the operating instructions in section 4.4.
Bell TV:
Choose your desired Bell service option, then go to section 4.3 receiver configuration.
After performing the check switch test, use the operating instructions in section 4.4.
IMPORTANT! DISH CUSTOMERS ONLY!
If you have a DISH model ViP
®
211z, ViP211k, ViP211 or 411 single tuner HD receiver, you can use the
simplified KING Tailgater user interface on your receiver.
In section 4.2, Antenna Configuration, choose Tailgater Mode.
Turn on your TV, receiver and controller, and then go to section 4.6, Tailgater Mode (skip sections 4.3 and 4.4).
Switch and dish type settings for DIRECTV receivers:
DIRECTV SD
Switch Type: 02:Multiswitch • Dish Type: 01: 18” Round
DIRECTV SD with Locals
Switch Type: 02:Multiswitch • Dish Type: 02: 3-LNB (18 x 20”)
If your receiver does not offer one of these settings,
call KING at (952) 922-6889 ext. 173 for assistance.
The KING Quest will not work with SWM only receivers.
Older receivers: choose round dish-1 satellite
Older receivers: choose oval dish-2 satellites