King Kutter II 999995, Operator'S Manual

Page: 19 / 36

OPERATING INSTRUCTIONS
STEP 1
Before each use perform the maintenance described in maintenance section
(page 20).
STEP2
Read, understand, and follow the information on safety training, preparation,
starting and stopping safety, operational safety, transport safety warning sec-
tions of this manual (pages 12 thru 15).
STEP 3
With the rotary tiller positioned on level ground, adjust the tractor lift arms so
that when lifted, the rotor bar remains parallel to the ground.
STEP 4
With the rotary tiller attached to the tractor, raise and support the tiller with
suitable blocks. Adjust the skids, located on the sides of the tiller. The adjust-
ment bolts for both right and left sides should be positioned in the same ad-
justment hole. This allows the tiller to till the same depth on each side. Adjust
the back plate, with regulating chain, until the desired mulching effect is found.
Note: Never attempt to adjust the rotary tiller while the tractor is
running.
STEP 5
Raise the tiller and remove the blocks. Lower the tiller to the ground.
STEP 6
With the tractor at idle RPM and the tiller lifted off of the ground, engage PTO
and slowly advance throttle to 540 PTO RPM. NOTE: Rotary tiller is designed
to run at 540 PTO RPM only.
STEP 7
Select a low gear for the tractor and begin to move forward. Tractor ground
speed is to be controlled by gear selection only and not engine speed. As the
tractor moves forward, slowly lower the tiller down. Allow the tiller tines to
gradually engage the ground.
19