MAINTENANCE
MAINTENANCE
CANISTER FILTER
For best performance, it is recommended on a regular basis to disloge dust from
the inside of the canister filter, this is done by turning the canister filter handle
(A) Fig.20.
MOTOR
Excessive dust in the motor could cause excessive heat. Every effort should be
made to prevent foreign material from entering the motor. A visual inspection
should be made at frequent intervals. Accumulations of dry dust can usually be
blown out to prevent the interference with normal motor ventilation. To remove
dust, blow off motor with a low pressure air hose.
The operator performing this cleaning function should wear safety glasses and
a filter mask. If any servicing (other than the above cleaning) becomes
necessary, it should be performed by an authorized service centre.
CAUTION:
WEARING A PARTICLE MASK/RESPIRATOR FOR PROTECTION AGAINST FINE DUST PARTICLES DURING CLEANING IS
HIGHLY RECOMMENDED.
Use the proper type of hose to connect the cyclone dust collector to the machine being operated. A dryer vent hose is not acceptable for this
purpose.
REPLACEMENT DRUM BAGS AND CANISTER FILTER BAG KIT
A 6pc. kit including 5 drum bags and 1 canister filter bag is available for each Cyclone Dust Collector as follows:
KDCB-82 (fits KC-8150C and KC-8200C)
KDCB-83 (fits KC-8300C)
Contact your distributor of King Canada products for more information.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.
FIGURE 20
